Case 4

Circuit Breaker Test

The challenge was to replace a manual test station for circuit breakers. Operators were manually loading and unloading circuit breakers into sockets of a test stand and then sort the good and reject units based on a series of lights. Repetitive motion was a constant concern and operator mistakes led to high warranty costs.

The solution was to robotically load the circuit breakers into the test stand and then sorted the complete units between good and three different types of rejects.

The circuit breakers were fed automatically by a vibratory feeder and presented two at a time to the robot. They were then placed into one of four sets of two test sockets and a defined amperage is applied. The extension of the reset button is checked with a photoelectric sensor. After the breaker opens, or times out, the robot removes the units, drops any failed units and places good units into a shipping tray.  The shipping trays are automatically stacked and an empty is loaded automatically so that the system can run over an hour's production without operator intervention. The tray stackers were unique in that they each were operated using only one pneumatic cylinder.  The testing cost was drastically reduced, repetitive motion was no longer an issue and warranty issues were reduced significantly.

The mechanic design, electrical design, PLC programming, and robot programming were all completed by our founder early in his career.


(Click on the picture to see more about this project.)

 

[Home] [Engineering] [Troubleshooting] [Coaching] [Forensics] [References] [Samples] [About Us] [Our Founder] [Contact Us] [Quips & Quotes] [Blog]

Copyright 2011 Innalytical Solutions Inc.