The challenge was to provide a machine that would disassemble a three piece rim assembly and then assemble the complete pneumatic tire. The tires are used on off-road equipment excavating equipment and weigh up to 1,500 pounds. The tire design presented many...
The challenge was to design a scissors lift table that could be readily converted from hydraulic to pneumatic power or changed between three different lifting capacities. The solution was a modular design with bolted joints. Five basic frame sizes were utilized to...
The challenge was to design a mechanism to drive an internal adjustment (regulation) using an external electric motor, while also providing feedback from the adjustment mechanism, or by using a hand tool. The solution was a unique combination of drive components...
The challenge was to design a table that tips a large components from vertical to horizontal (upender) with enough strength to support the loads. The solution was created using SolidWorks to design a heavy duty tilt mechanism and then analyzing the stresses using the...
The challenge was to design a modular fixture that would allow multiple products to be assembled and tested within the same assembly cell. The solution was a series of small modular fixtures based on die stamping components that allowed various parts to be assembled...
Recent Comments