The challenge was to securely restrain the XYZ table described in Case #2 while still allowing for the table to be positioned in four axis. The solution was a locating pin that could float with the movement of the table and then be locked into position. As the table...
The challenge was to raise an entire vehicle body off of a conveyor system and located it in the X, Y, Z and Theta axes. The Z axis was required to raise 36 inches in order to lift the body off the carrier. The body also had to be located to less than 0.001″...
The challenge was to maintain the the air gap between the stator and rotor of an electric motor while the end plates were clinched to the stator assembly. The solution was to create a shim pack assembly that was attached to the rotor before it was inserted into the...
The challenge was to replace a manual test station for circuit breakers. Operators were manually loading and unloading circuit breakers into sockets of a test stand and then sort the good and reject units based on a series of lights. Repetitive motion was a constant...
Recent Comments